CERAMIC SHAMPOO

Ceramic Shampoo from Mafra’s Maniac Line™ is a product with a 3-in-1 formula that washes, seals and protects for 90 days in a single operation. Also ideal for maintenance, Ceramic Shampoo increases and enhances the properties of the wax, sealant and ceramic coating previously applied to the surface.

• Gives the surface a self-cleaning hydrophobic ability
• Allows you to keep your car clean longer
• 3 in 1 formula: washes, seals and protects the bodywork for 90 days
• Leaves the surface silky giving a shine equal to a wax in a jar
• Contains super idophobic SiO2 ceramic polymers

Watch how easy it is

YOU CAN USE CERAMIC SHAMPOO AS OFTEN AS YOU WANT, AS PROTECTION OR MAINTENANCE OF THE PROTECTIONS APPLIED TO THE BODYWORK

To promote adhesion and maximize the duration of protection, the vehicle must first be thoroughly decontaminated. Based on contamination
present you can use Iron Remover to remove ferrous contamination strongly anchored to the surface and Water Spot Mineral Remover,
specific decontaminant for the removal of limescale stains.
You can use Ceramic Shampoo to obtain an instant hydrophobic effect similar to the protective effect of ceramic coatings. Is critical
use the shampoo from the bottom up, therefore not like a normal car shampoo, this is because when applying the product, being a
polymer, if I started from the top I could leave drips obtaining a non-uniform coverage. Starting from the bottom, we will get a cover
uniformity of the surface minimizing the risk of leaving streaks or halos.
The product is highly dilutable, with just one bottle you can wash your car 18 times!

CERAMIC SHAMPOO

BUY NOW!

WE SUGGEST THESE SIMPLE STEPS TO MAKE THE MOST OF THE PRODUCT

STEP 1

Dilute 4 capfuls of Ceramic Shampoo in a bucket of water

STEP 2

Spread the product with a microfibre glove or pad, starting from the bottom and always with the vehicle wet.
Let it act for a few minutes

STEP 3

Rinse thoroughly with high pressure water

STEP 4

Proceed with drying with an ultra-absorbent cloth

CERAMIC SHAMPOO

BUY NOW!

HOW TO INCREASE THE SELF-CLEANING EFFECT OF CERAMIC SHAMPOO?

To enhance the self-cleaning properties of the Ceramic Shampoo from the Mafra Maniac Line you can follow two methods:

1. The first method is with a microfiber glove or pad, the same used for washing. Dilute the product in the ratio 1:5 (1 part of product and 5 of water). Spray the solution obtained on the same washing pad or glove and distribute over the whole car without omitting any points.

2. The second method is with Foam Gun technique. Dilute the product in the ratio 1:3 (1 part of product 3 parts of water). Dispense the solution obtained with the foaming technique, all over the car from bottom to top. Wait at least 1 minute and rinse starting from top to bottom

CERAMIC SHAMPOO

Watch how easy it is

YOU CAN USE CERAMIC SHAMPOO AS OFTEN AS YOU WANT, AS PROTECTION OR MAINTENANCE OF THE PROTECTIONS APPLIED TO THE BODYWORK

CERAMIC SHAMPOO

WE SUGGEST THESE SIMPLE STEPS TO MAKE THE MOST OF THE PRODUCT

STEP 1

STEP 2

STEP 3

STEP 4

CERAMIC SHAMPOO

HOW TO INCREASE THE SELF-CLEANING EFFECT OF CERAMIC SHAMPOO?

EXPERT ADVICE

MAKE SURE THAT THE SURFACE OF THE VEHICLE IS NOT HOT AND THAT THE CAR IS IN THE SHADE AVOIDING DIRECT SUN

CARRY OUT A PREWASH WITH “FOAM GUN PREWASH” TO REMOVE COARSE DIRT AND FACILITATE THE NEXT MANUAL WASHING PHASE

USE THE TWO BUCKET WASHING METHOD (ONE WITH THE CERAMIC SHAMPOO/WATER SOLUTION AND THE OTHER WITH ONLY CLEAN WATER) WITH A MICROFIBER PAD OR GLOVE